In order to play a role in the production of spiral bevel gears, it is very important to carry out the correct assembly. If the assembly work is done better, then what should be paid attention to when assembling the spiral bevel gears?

1. When installing the mechanical spiral bevel gear, it should be noted that the contact spot of the two gears meshing tooth surface must be more than 70%; at the same time, we can adjust the thickness of the gasket to adjust the two gear meshing. Clearance, this gap can not be too large or too small, otherwise it will affect our use.

2. For the assembly of the spiral bevel gear, we need to adjust the center line of the two shafts to the same plane before the next assembly can be performed.

3. The coloring inspection of the spiral bevel gear contact surface, we need to pay attention to the fact that the shaft can not be strung during the rotation process, and the contact surface should be close to the gear small head without load. Therefore, the spiral bevel gear needs to pay attention to these details when assembling, so as to ensure the good performance of the spiral bevel gear.